[Disabling Secure Boot in BIOS] / [在BIOS中禁用安全启动]
Click to expand / 点击展开-
Before you disable SECURE BOOT please make sure you DO NOT have Bitlocker enabled. If you have Bitlocker enabled, please first turn it off and decrypt your disk.
在你禁用SECURE BOOT之前,请确保你没有启用Bitlocker。如果你启用了Bitlocker,请先关闭它并解密你的磁盘。 -
Boot and enter BIOS. / 启动并进入BIOS。
-
Depending on your motherboard manufacturer, BIOS key set by your manufacturer which could be F1, F2, F10, F11, F12, ESC, or DEL.
根据你的主板制造商,BIOS键由你的制造商设置,可能是F1、F2、F10、F11、F12、ESC或DEL。
-
Depending on your motherboard manufacturer, BIOS key set by your manufacturer which could be F1, F2, F10, F11, F12, ESC, or DEL.
-
Go to [Security] or [Boot] tab and select [Secure boot]. Set it to [Disabled].
进入[安全]或[启动]标签,选择[安全启动]。将其设置为[已禁用]。-
Some manufacturers may use different names or menus to control [Secure boot] state.
一些制造商可能使用不同的名称或菜单来控制[安全启动]状态。 - Asus:
-
Enter [Key Management]
进入[钥匙管理]。 -
Select "Clear All Keys"
选择 "清除所有按键" -
Set OS type to "Other OS"
将操作系统类型设置为 "其他操作系统" -
Set Secure Boot Mode to "Standard"
将安全启动模式设置为 "标准"。
-
Some manufacturers may use different names or menus to control [Secure boot] state.
-
Go to [Save & Exit] tab [Save Changes] and select [Yes].
进入[保存和退出]选项卡[保存更改]并选择[是]。 -
Then, select [OK] to restart.
然后,选择[OK]重新启动。
[Disabling Fast Boot in BIOS] / [在BIOS中禁用快速启动]
Click to expand / 点击展开-
Boot and enter BIOS. / 启动并进入BIOS。
-
Depending on your motherboard manufacturer, BIOS key set by your manufacturer which could be F1, F2, F10, F11, F12, ESC, or DEL.
根据你的主板制造商,BIOS键由你的制造商设置,可能是F1、F2、F10、F11、F12、ESC或DEL。
-
Depending on your motherboard manufacturer, BIOS key set by your manufacturer which could be F1, F2, F10, F11, F12, ESC, or DEL.
-
Go to [Boot] select [Fast boot] and set as [Disabled].
进入[Boot]选择[Fast boot]并设置为[Disabled]。-
[Fast boot] may also be found on some motherboards in the following menu options:
[快速启动]在一些主板上也可以在以下菜单选项中找到:- Boot configuration / 启动配置
- Boot Settings / 启动设置
-
[Fast boot] may also be found on some motherboards in the following menu options:
-
Go to [Save & Exit] tab [Save Changes] and select [Yes].
进入[保存和退出]选项卡[保存更改]并选择[是]。 -
Then, select [OK] to restart.
然后,选择[OK]重新启动。